FS2004 - photoreal panel Boeing 747-400 with full internal views incl. 3 animated wingviews
for Project Opensky B747-400 and prepared for TCAS and RADAR, usable
for any other B747-400 without wingviews / by Horst Paetzold
Important: To use TCAS, you need to have ( installed in FS9) TCAS II V7.0 from Lee Hetherington and
to use RADAR you need the same for Eric Marciano's RADAR-Gauge
(both not contained in this upload)
Installation: Unzip panel-zip into the panel-folder of your Aircraft (make backup before)
Unzip gauges-zip into the gauges-folder of FS9
Some hints for the usage of this panel:
The 4 engine-startvalve-switches are right of the battery switch in the overhead-part of the panel.
The radio-switch is on the foremost-left addition of the glareshield
Because I found no way to incorporate the 4 Fuel-RUN/CUTOFF-switches into the panel, please use for
this the keyboard-commands CTRL+SHIFT+F4 for ON and + F1 for OFF.
The settings for "RADIOS" in your aircraft.cfg should read as follows: