The engine was designed as a P&W Wasp Jr. but is easily modified/sized to be about any radial. All parts are 'child' parts of the case to facilitate easy positioning in your project. A picture of the Williams Bro.s model engine was used and a bmp backdrop is included. The P&W insignia was taken from a picture of the EAA's Ford Tri-Motor so its appropriate for a plane of that era. One minor glitch is that the cylinder texture appears upside down in the 3D view however shows properly in FS2002. Also included is a partial spread sheet of P&W engine specs, more can be found on their web site.
For use in any FSDS2 or newer aircraft. It has not been tested on earlier versions. Feel free to use without permission in any freeware aircraft.
I would appreciate a note as to where the engine ends up but that's not required, however please give proper attribution.
Not to be used in any form in commercial aircraft without prior written consent of the author.
