---------------------------------------------------------------------
FSX 2D Cockpit Panel for the Transavia PL12 AirTruk

built by: Dean Stringer (deeknow@pobox.com)
released: 21/Feb/2011
---------------------------------------------------------------------

This panel is based on photographs of real AirTruk aircraft cockpits
and can be used as a 2D panel in conjunction with any AirTruk model.

The Transavia PL-12 Airtruk is a single-engine agricultural biplane
aircraft designed and built by the Transavia Corporation in Australia.
The Airtruk is of all metal construction with the cockpit mounted
above a tractor engine and short pod fuselage with rear doors. It has
twin tail booms with two unconnected tails

To retain something of the original feel of the gauges typically seen
in an AirTruk two of the gauges have been borrowed from the default
FSX Robinson R22 helicopter. For this panel to work correctly you
must complete all of the following steps:

1. PANEL INSTALLATION

* copy the folder "panel.dno" into your AirTruk folder under the
main FSX airplanes folder

* edit your AirTruk aircraft.cfg file and change each aircraft
entry to specify the new panel in the following way

panel=dno

2. GAUGE INSTALLATION

* copy the file Robinson_R22.cab from the following folder
into the new panel.dno folder created above:

\SimObjects\Rotorcraft\Robinson_R22\panel


Re-load your AirTruk and you are away.

All other gauges are taken from default FSX Cessna 172/182 gauges
and should not need to be configured by you.

Good luck, hope you enjoy using the panel, and feel free to drop
me an email if you have any feedback or suggestions for changes.

Dean


Please note: the AirTruk image contained in this archive is from
wikipedia and shared under the CreativeCommons license, please see
the following page for details:
http://en.wikipedia.org/wiki/File:Airtruk.jpg