1. Reworked part of the riverfront--including terrain and textures.
2. Added wharf and a set of steps.
3. Changed apron surfaces to concrete and enlarged some of the
aprons.
4. Removed invisible crash box from one of the aprons.
5. Moved all taxi signs into correct position.
6. Removed parking codes from parking spaces that had them.
7. Added fences to much of the perimeter.
8. Replaced one of the hangars with a more appropriate model.
9. Provided additional lighting.
10. Added vehicles to the fire station and to a few other airport
locations.
11. Moved the water tower and added the second water tower.
12. Removed conflicts between buildings and aircraft parking spaces
without deleting any of the extensive parking.
13. Repositioned helipads to avoid conflicts with other traffic.
14. Changed density at which all buildings appear to "normal" or
higher.
15. Added the control tower.
Tested and developed for FSX Deluxe with Acceleration Expansion
Pack running with "Preview DirectX 10" enabled.
Enjoy!
Dan Mesmer
I N S T A L L A T I O N
ALL USERS
Copy all of the files in the "Texture" folder (but not the
"Texture" folder, itself) to the main FSX "Texture" folder. There
is no need to overwrite any files that are found to already exist
within the FSX "Texture" folder. Complete the installation as
shown below.
TRAFFIC X USERS
All Traffic X users should navigate to the following folder:
In the above folder, rename AF2_KNIP.bgl to AF2_KNIPbgl.bak
There are two methods to complete the installation for Traffic X
users. One method is to use the procedure shown below for "NON-
TRAFFIC X USERS," thereby adding "KNIP Enhanced" to the FSX
Scenery Library. The other method is this:
Within the "KNIP Enhanced" folder is a "Scenery" subfolder. Copy
all files within this "Scenery" subfolder (but not the "Scenery"
subfolder, itself), and paste the files into:
1. Copy the "KNIP Enhanced" folder (including the folder, itself)
to the FSX "Addon Scenery" folder.
2. In FSX, go to "Settings," and under "Other settings," click
the "Scenery Library" button.
3. On the "Settings - Scenery Library" window, click the "Add
Area" button.
4. Navigate to the "Addon Scenery" folder, and then double-
click on the folder to open it.
5. Click once on "KNIP Enhanced," and click the "OK" button.
6. Clicking the "OK" button above has brought you back to the
"Settings - Scenery Library" window. Under "Available scenery
areas," "KNIP Enhanced" will appear at the top of the list.
Be sure "Enabled" is checked, then click the "OK" button.
A C K N O W L E D G E M E N T S
SPECIAL THANKS TO:
Jim Dhaenens (jdhaenens@sbcglobal.net) for modeling the hangar
reproduction. The model is Copyright 2008-2009 Jim Dhaemens. It
has been used by permission.
Jon Masterson and team for developing Airport Design Editor FSX
Edition (ADE9X v.1.45.06). Copyright 2007-2009 ScruffyDuck
Software.
____________________
This software is freeware and may be distributed only with
permission of the author. No commercial use is allowed without
the author's permission.
This software is distributed without warranty of any kind either
expressed or implied. The author is not responsible for any
damage caused by this software.
All original material is Copyright 2009 Daniel W. Mesmer.
All Rights Reserved Worldwide.
