*******************************************************************************
Science Fiction Animation Plastic Model Series No.31.
S.H.A.D.O. Sky One (with SkyDiver)
(based on Gerry Anderson's TV Series "U.F.O.")
by Kazunori Ito
*******************************************************************************
1.Description of this aircraft
2.Specification
3.About the installation
4.About the operations
5.About free software
6.About the directions point in FS2004 and FSX
*******************************************************************************
!!!!! <
> !!!!!
This aircraft is set as a hydroplane.
Please take off from the sea or the lake.
SkyDiver is related to Center Gear.
Therefore, it separates and dives by pushing "G" key during the leaving the water slide.
When you leave the water Sky One with Gear not stored, SkyDiver also flies away to the sky.
Please note it.
Moreover, though the take off from a usual land glide slope is also possible, please avoid it as much as possible because Sky Diver slips into ground.
For the person who wants to see the whole image of SkyDiver, Slowly appreciating in the air might be happy.
However, because a center point of this aircraft is set to the center of Sky One, the back of SkyDiver is not seen easily a little.
------------------------------------------------------------
Skydiver was an advanced attack submarine operated by SHADO in their war against the aliens.
The organization operated three such vessels, whose existence was top secret.
The front part of the sub was an aerial fighter (Sky One), which could launched from beneath the surface of the water to maintain secrecy and use the element of surprise in ambushing UFOs already in the atmosphere.
The Skydivers were berthed in underground docks (in Britain and presumably elsewhere), linked to the sea by long tunnels.
Skydiver had about a four-man crew, with the captain usually serving as the pilot for Sky One, a twin-engine fighter.
Its primary offensive armaments were two missile pods slung under the craft's small wings and four nose-mounted cannons.
A boarding tunnel ran from the control room of Skydiver, through the back of Sky One and into the cockpit area.
This way the craft could be quickly scrambled in combat situations.
--------------------------------------------------
2. [ Specification ]
Unknown
-------------------------------------------------
3. [ About the installation ]
The airframe must copy the \SHADO SkyOne (SkyDiver) folder as it is in the Aircraft folder of FS2002 or FS2004.
\FS2002(FS2004)
-----\Aircraft
---------\SHADO SkyOne (SkyDiver)
Please copy all files in the \gauges folder onto the gauge in the Gauges folder of FS2002 or FS2004.
A general gauge is saved for the gauge bundled this time.
The gauges of EXTRA-300 and Kingair, Beech_Baron, GPS are not bundled.
Please setup it by yourself.
-----------------------------------------------------------
4. [ About the operations ]
"G" = SkyDiver separate and erase
A special key operation is not used for this model.
-----------------------------------------------------------
5. [ About free software ]
All aircraft that I made are free software.
The reprint and the repaint may go freely.
However, please defend the following conditions.
1.The change in contents of this file is prohibited.
(Please distribute it like the Zip file of the current state when distributing it. )
2.Please neither reverse-assembly nor never remodel(convert) it of the aircraft model.
3.Please don't bundle my airframe(MDL file) in the package of your works when you open the repaint to the public.
(Please open only the texture to the public. )
4.Don't use DXT format for making texture.
Please make it by the format that everyone can change.
It is necessary to be able to read and change with usual drawing software.
5.It is prohibited to bundle and to open a new panel to the public to my aircraft model.
(Please open only the panel to the public.
It is included in this file, and remodeling the panel that uses the panel background and the change in the panel background are prohibited. )
6.I maintain the copyright of the aircraft model and the panel background.
7.The copyright of the gauge belongs to the author.
---------------------------------------------------------
6. [ About the directions point in FS2004 and FSX]
This aircraft model is made by using FSDS Ver2.24.
Therefore, it is possible to play basically in FS2004(FS9) and FSX(FS10).
However........!!
In FS2004.
For a wide large-scale aircraft, the distortion is caused and the phenomenon of the aerofoil tip's disappearing happens in the spot shooting mode.
If this phenomenon happens, Please switch to the spot shooting mode by using other small aircraft.
Afterwards, if this aircraft is selected, it is normally displayed.
And........
In FSX.
Because gauges do not correspond to FSX, the gauges in the cockpit are not displayed.
Please you looks for a suitable gauges and setup Panel.cfg by yourself.
Sorry...............
*******************************************************************
Please Notice
I like military aircrafts. Especially, fighter!!
But, It is because the shape is unique and the manoeuverability is good.
I like aircraft that can freely fly in the big sky.
However............I hate war and combatting.
When I thinks the airframe that I made launches the bullet and the missile, I become scary.
Therefore, I'm prohibiting convert of my airframe for CFS.
If it is possible, I am wishing my airframe not to be used in CFS.
Though you might be said "Because it's simulation world"..........
Please..........Please.......
*******************************************************************
Please give mail to the following mail address when there is a recommendation of making the opinion and the thing that doesn't come.
KazuIto0926@aol.com
2008/06/13
Fukuoka, Japan
*******************************************************************
