Glider Go242 for the invasion will obtain the authorization of a German Air Ministry because it had the load capacity three times transportation glider DFS230 that German army was using till then and start the mass production type development.
And, the airframe to which this machine also had had power was developed as well as other gliders for the invasion.
Because obtaining a large amount of Gnome Rhone 14M engines after France surrenders just became possible, this was installed and Go244 that had a fixed undercarriage was developed.
All these gliders with power were redecorating from powerless type Go242B.
In a part of airframe, BMW132Z engine (660hp) and captured Shuvestof M25A (750hp) made in the Soviet Union engine are installed.
However, because Go244 was a low-speed flying speed and a stolid maneuverability, damage by the combined force fighter becomes extensive, it has been improved from the front by the end of 1942.
Wing span: 80 ft. 4? in. (24.50m)
Length: 51 ft 10 in. (15.81m)
Height: 15 ft. 5 in. (14.70m)
Wing Surface Area: 693.22 sq. ft. (64.40m2)
Empty Weight: 11,245 lbs. (5100 kg)
Maximum Weight: 17,198 lbs. (7800 kg)
Engine: Gnome Rhone 14M4/5 (14-Cylinder Radial 700 hp) X 2
Sometimes BMW 132Z or Russian M-25A engines installed.
Maximum Speed: 180 mph (290 kph)
Service Ceiling: 24,605 ft. (7500m)
Range at sea level: 272 Miles (600 km)
Armament: Four 7.92mm MG 15 Machine guns.
-----------------------------------------------------------
[ About the installation ]
The airframe must copy the \Go244 folder as it is in the Aircraft folder of FS2002 or FS2004.
\FS2002(FS2004)
-----\Aircraft
---------\Go244
Please copy all files in the \gauges folder onto the gauge in the Gauges folder of FS2002 or FS2004.
A general gauge is saved for the gauge bundled this time.
Cessna, Cessna182S, Beach_baron, EXTRA-300, Kingair, GPS are not bundled.
Please introduce it by yourself.
-----------------------------------------------------------
[ About the operations ]
Shift+"E" = EXIT Door Open/Shut
................................
!! A special key operation !!
................................
(Shift+"E")+"2" = Rear CargoBay Door Open/Shut
Shift and "E" are pushed at the same time. afterwards, please push "2".
"2" Key is "2" of the main keyboard.
It doesn't move by "2" of ten keys.
-----------------------------------------------------------
[ About free software ]
All aircraft that I made are free software.
The reprint and the repaint may go freely.
However, please defend the following conditions.
1.The change in contents of this file is prohibited.
(Please distribute it like the Zip file of the current state when distributing it. )
2.Please neither reverse-assembly nor never remodel(convert) it of the aircraft model.
3.Please don't bundle my airframe(MDL file) in the package of your works when you open the repaint to the public.
(Please open only the texture to the public. )
4.Don't use DXT format for making texture.
Please make it by the format that everyone can change.
It is necessary to be able to read and change with usual drawing software.
5.It is prohibited to bundle and to open a new panel to the public to my aircraft model.
(Please open only the panel to the public.
It is included in this file, and remodeling the panel that uses the panel background and the change in the panel background are prohibited. )
6.I maintain the copyright of the aircraft model and the panel background.
7.The copyright of the gauge belongs to the author.
---------------------------------------------------------
[ About the directions point in FS2004 ]
This aircraft model is made by using FSDS Ver2.24.
Therefore, it is possible to play basically in FS2004(FS9).
However........!!
For a wide large-scale aircraft, the distortion is caused and the phenomenon of the aerofoil tip's disappearing happens in the spot shooting mode.
If this phenomenon happens, Please switch to the spot shooting mode by using other small aircraft.
Afterwards, if this aircraft is selected, it is normally displayed.
*******************************************************************
Please give mail to the following mail address when there is a recommendation of making the opinion and the thing that doesn't come.
KzIT16643VT@aol.com
2005/10/05
Fukuoka, Japan
*******************************************************************
