This aircraft is an completely unknown aircraft.
In the WWII end, it is one of the original bills of the aircraft development that a German air force planned.
This was a flying-wing fighter-bomber project whose first rototype made its maiden flight in 1945.
It is expected performance and armament were great and it was the first flying-wing with turbojets.
There was a B version planned which was intended as night fighter with radar and 2 crew member.
One of the main drawbacks of this design was that it was limited in the choice of engines; for example, the sronger HeS 011 turbojet, which was in development, would have had a too big diameter for fitting it into the engine slots of this flying-wing.
This was one of the main reasons why the Gotha engineers which recieved the Ho IX plans for production preparations designed the Gotha project Go P.60 with each one tubojet over and under the centerline.
Range:
1,970 miles (3170km) at 393mph (635km/h) with two drop tanks
Armaments: Planned
Four Mk 103 or Mk 108 cannon
Plus
Two 1,000kg bombs
Crew:
Type A : 1
Type B : 2
-----------------------------------------------------------
[ About the installation ]
The airframe must copy the \HO-229 folder as it is in the Aircraft folder of FS2002 or FS2004.
\FS2002(FS2004)
-----\Aircraft
---------\HO-229
Please copy all files in the \gauges folder onto the gauge in the Gauges folder of FS2002 or FS2004.
A general gauge is saved for the gauge bundled this time.
EXTRA-300, GPS gauges are necessary besides the bundled gauge.
It is necessary to introduce no possession of these gauges separately.
-----------------------------------------------------------
[ About the operations ]
A special key operation is not used for this model.
-----------------------------------------------------------
[ About free software ]
All aircraft that I made are free software.
The reprint and the repaint may go freely.
However, please defend the following conditions.
1.The change in contents of this file is prohibited.
(Please distribute it like the Zip file of the current state when distributing it. )
2.Please neither reverse-assembly nor never remodel it of the aircraft model.
3.Please open only the texture to the public when you open the repaint to the public.
(Opening in the state to bundle my aircraft model to the public is prohibited. )
4.It is prohibited to bundle and to open a new panel to the public to my aircraft model.
(Please open only the panel to the public.
It is included in this file, and remodeling the panel that uses the panel background and the change in the panel background are prohibited. )
5.I maintain the copyright of the aircraft model and the panel background.
6.The copyright of the gauge belongs to the author.
---------------------------------------------------------
[ About the directions point in FS2004 ]
This aircraft model is made by using FSDS Ver2.24.
Therefore, it is possible to play basically in FS2004(FS9).
However........!!
For a wide large-scale aircraft, the distortion is caused and the phenomenon of the aerofoil tip's disappearing happens in the spot shooting mode.
If this phenomenon happens, Please switch to the spot shooting mode by using other small aircraft.
Afterwards, if this aircraft is selected, it is normally displayed.
*******************************************************************
Please give mail to the following mail address when there is a recommendation of making the opinion and the thing that doesn't come.
