I think that it is more that it is of "Howl's Moving Castle" of the Hayao Miyazaki supervisor work.
This time, the Howl's Castle in the flying type that flew to backing of the ending roll was made 3D.
I wanted to make it since before.
However, because the form was too complex, Where it starts it is not understood and I was discontinuing its making.
A detailed setting of the castle doesn't come out even in Diana Wynn Jones's original book.
However,
EPSON opened the papercraft in this flying type to the public as free software the other day (June 20).
The purpose is to campaign for the event "Howl's Moving Castle large circus exhibition".
I was immediately download it !!.............. wonderful.
It is possible to download it from the following sites so that it may be interested, and there is not obtaining yet.
However, because it is a limited time event (fully August), to bringing forward.
This castle was made by making and the simultaneous concurrency of the papercraft.
However, there is a part that also my favor, and is slightly different in the size in the body etc. , too.
Moreover, the settings of the moving parts are all due to my arbitrary decision and the prejudice.
When the tongue was put in and out for a moment too much, the attention of regret d also :.
Anyway, The castle where Soffy and Howl were put that had become happy flies calmly with the power of Calshifar.
Throat.........................
At this time, Panel is not bundle in this package.
-----------------------------------------------------------
[ About the operations ]
A special key operation is not used for this model.
Shift+"E" = Entrance Door Open/Shut
This aircraft is setting it to about 45m in total length.
Because a detailed spec was not understood........
Suitably !!
Flight Dynamics adjusts and uses the thing of V-22 Osprey again.
-----------------------------------------------------------
[ About free software ]
All aircraft that I made are free software.
The reprint and the repaint may go freely.
However, please defend the following conditions.
1.The change in contents of this file is prohibited.
(Please distribute it like the Zip file of the current state when distributing it. )
2.Please neither reverse-assembly nor never remodel it of the aircraft model.
3.Please open only the texture to the public when you open the repaint to the public.
(Opening in the state to bundle my aircraft model to the public is prohibited. )
4.Don't use DXT format for making texture.
Please make it by the format that everyone can change.
It is necessary to be able to read and change with usual drawing software.
5.It is prohibited to bundle and to open a new panel to the public to my aircraft model.
(Please open only the panel to the public.
It is included in this file, and remodeling the panel that uses the panel background and the change in the panel background are prohibited. )
6.I maintain the copyright of the aircraft model and the panel background.
7.The copyright of the gauge belongs to the author.
---------------------------------------------------------
[ About the directions point in FS2004 ]
This aircraft model is made by using FSDS Ver2.24.
Therefore, it is possible to play basically in FS2004(FS9).
However........!!
For a wide large-scale aircraft, the distortion is caused and the phenomenon of the aerofoil tip's disappearing happens in the spot shooting mode.
If this phenomenon happens, Please switch to the spot shooting mode by using other small aircraft.
Afterwards, if this aircraft is selected, it is normally displayed.
*******************************************************************
Please give mail to the following mail address when there is a recommendation of making the opinion and the thing that doesn't come.
KzIT16643VT@aol.com
2005/07/05
Fukuoka, Japan
*******************************************************************
