[lists]
0=&INT, Martin M-130 Checklists
1=&Start Engines and Warm Ups, Start Engines and Warm Up
2=&Testing Engines & Installations, Testing Engines and Installations
3=&Pre-Taxi Checks, Pre-Taxi Checks
4=&Pre-Take Off Checks, Pre-Take Off Checks
5=&Take Off Checks, Take Off Checks
6=&Climb Checks, Climb Checks
7=&Flying Limitations, Flying Limitations
8=&Landing Checks, Landing Checks
9=&Missed Approach Checks, Missed Approach Checks
10=&After Landing Checks
[0]
0=This series of checklists are for use with the Martin M-130
1=Written by Daniel Nole
[1]
0=Mixture and Propellors set full.
1=Start Engines.
2=Check Flying Controls for freedom of movement.
3=Adjust seat height (Shift+Enter x 2).
4=Retract FLAPS (Press F5).
[2]
0=Ensure Autopilot disengaged (Shift + 3)
1=Check FLIGHT CONTROLS for freedom of movement.
2=Set MIXTURE full rich. (Full Up)
3=Set PROPELLOR controls. (Full Up)
4=Perform Run Ups on Each Engine.
[3]
0=Navigation Lights On if required (Press L)
1=Altimeter Set to Latest QNH
2=Use outside engine for turns while taxying.
3=Water Rudder down with shift Z
[4]
0=Turn PITOT HEAT On (Press H)
1=Set ELEVATOR TRIM 1/2 notch nose up
2=Ensure PROPELLER CONTROLS Full Up (Cntrl + F4)
3=Ensure FUEL TANK SELECTOR set to ALL.
[5]
0=Mix medium in engines
1=Advance throttles to full up (Press F4).
2=Climb at 105 kts ,300-500 fpm
3=Cruising 132-139 kt/5.000 ft
[6]
0=Recommended speed for quick climb 105 kt.
1=Set ELEVATOR TRIM and adjust throttles as needed.
2=Most comfortable climbing speed is 104 kt.
3=Set FUEL TANK SELECTOR to desired tank(s).
4=On reaching cruise altitude set controls as desired.
5=Cruise at 132 to 139 kt.
[7]
0=Stall Speeds (83 kt clean) (67 kt dirty)
1=Max diving speed 192 kt
2=Spins and aerobatics not permitted.
3=Violent use of rudder at high speeds to be avoided.
4=Max flap speed 192 kt.
[8]
0=Ensure Autopilot Disengaged.
1=Reduce speed to below 150 kt.
2=Set FLAPS to 20 degrees (Press F2 twice) in the circuit.
3=FLAPS full down on final approach.
4=Set FUEL TANK SELECTOR to ALL.
5=Approach at 100 kt gliding.
[9]
0=Climb out at 104 kt.
1=Raise flaps one notch at a time and trim as required.
[10]
0=Raise FLAPS (Press F5)
1=Once at harbor area shut down engines.
