[lists]
0=&Cover, Aircraft Checklist Focke-Wulf Fw 190A
1=&Takeoff, Takeoff Checklist
2=C&ruise, Cruise Checklist
3=&Descent, Descent Checklist
4=&Landing, Landing Checklist

[0]
0=Note - Press Shift+C to cycle the following checklists:
1=1. Takeoff
2=2. Cruise
3=3. Descent
4=4. Landing

[1]
0=To start engine - press the "E" key.
1=Check flight controls.
2=Smoothly increase throttle.
3=Hold tail down until sufficient speed (135-145km/h) attained, then raise tail slowly.
4=At about 185-190km/h ease back on the stick.
5=Gradually adjust pitch attitude to climb at 258km/h.
6=Retract the landing gear.

[2]
0=Establish level flight.
1=Power setting for cruise at 6.500m 2350 rpm - 1.23 ATA=460-470km/h.
2=Adjust elevator trim (Num Pad 7 = nose down, Num Pad 1 = nose up).

[3]
0=Reduce power to maintain glide speed of approximately 245-255km/h.
1=Relax pressure on the controls and the airplane will descend.
2=To level off, increase power to original cruise setting.

[4]
0=Reduce power to maintain glide speed of approximately 245-255km/h.
1=Lower gear below 250km/h and flaps as needed.
2=Adjust power settings for 235-245km/h final approach.
3=Over runway (200-210km/h), establish slight nose-up attitude. Reduce throttle to idle.