EXTRA 300S PROCEDURES

For detailed instructions on how to fly this aircraft, see the Aircraft Information section of Help. For suggested speeds, see the Reference tab.

____________________________________
BEFORE STARTING ENGINE

[ ] Brakes -- TEST AND SET
(press CTRL+PERIOD key)
[ ] Master Switch -- ON
[ ] Avionics Master Switch -- OFF
[ ] Electrical Equipment -- OFF
[ ] Alternator -- ON
[ ] Nav/Strobe Lights -- ON

____________________________________
ENGINE START

Press CTRL+E to initiate engine autostart sequence, or:

[ ] Propeller -- HIGH RPM
(press CTRL+F3 until fully in)
[ ] Mixture -- RICH
(press CTRL+SHIFT+F3 until fully in)
[ ] Throttle -- OPEN 1/4 travel
(press F3 or F2 as necessary)
[ ] Boost Pump -- ON
[ ] Ignition Switch -- START (release when engine starts)
(press M+PLUS key to R, L, Both, Start)
[ ] Boost Pump -- OFF

Then:

[ ] Oil Pressure -- CHECK
[ ] Avionics Master Switch -- ON

____________________________________
BEFORE TAKEOFF

[ ] Flight Controls -- FREE AND CORRECT
[ ] Flight Instruments -- CHECK and SET
[ ] Oil Pressure -- CHECK
[ ] Mixture -- RICH
(press CTRL+SHIFT+F3 until fully in)
[ ] Fuel Quantity -- CHECK
[ ] Throttle -- 1800 RPM
(press F3 or F2 as necessary)
[ ] Magnetos -- CHECK
<175 RPM drop on each, <50 RPM drop between
(press M+MINUS key then M+PLUS key to L, R, L, Both)
[ ] Propeller -- CYCLE high RPM/low RPM/high RPM
(press CTRL+F3 until fully in, then CTRL+F2 until fully out,
then CTRL+F3 until fully in)
[ ] Boost Pump -- ON (check fuel flow)
[ ] Engine Instruments and Ammeter -- CHECK
[ ] Throttle -- 800-1000 RPM
(press F2 or F3 as necessary)
[ ] Strobe Lights -- AS DESIRED
[ ] Avionics Master Switch -- ON
[ ] Radios and Avionics -- SET
(press SHIFT+2 to display radio stack)
[ ] Brakes -- RELEASE
(press PERIOD key)

____________________________________
TAKEOFF

[ ] Propeller -- HIGH RPM
(press CTRL+F3 until fully in)
[ ] Mixture -- RICH (may be leaned above 3000')
(press CTRL+SHIFT+F3 or CTRL+SHIFT+F2 as necessary)
[ ] Throttle -- FULL
(press F3 until fully in)
[ ] Elevator Control -- GENTLY PUSH FORWARD ON STICK
(until tail comes up)
-- At 65 KIAS pull back and fly off the runway
[ ] Propeller -- 2400 RPM
(press CTRL+F2 or CTRL+F3 as necessary)
[ ] Climb Speed -- 100 KIAS (normal climb)
[ ] Boost Pump -- OFF

____________________________________
CRUISE

[ ] Throttle -- AS DESIRED
(press F2 or F3 as necessary)
[ ] Propeller -- AS DESIRED
(press CTRL+F2 or CTRL+F3 as necessary)
[ ] Mixture -- LEAN
(press CTRL+SHIFT+F2 or CTRL+SHIFT+F3 as necessary)
[ ] Elevator Trim -- ADJUST
(with NumLock off press NumPad 1 or NumPad 7
as necessary)

____________________________________
DESCENT

[ ] Throttle -- REDUCE
(press F2 as necessary)
[ ] Mixture -- FULL RICH
(press CTRL+SHIFT+F3 until fully in)
[ ] Propeller -- 2400 RPM
(press CTRL+F2 or CTRL+F3 as necessary)
[ ] Elevator Trim -- ADJUST
(with NumLock off press NumPad 1 or NumPad 7
as necessary)

____________________________________
BEFORE LANDING

[ ] Boost Pump -- ON
[ ] Mixture -- RICH
(press CTRL+SHIFT+F3 until fully in)
[ ] Propeller -- HIGH RPM
(press CTRL+F3 until fully in)
[ ] Airspeed -- 80 KIAS

____________________________________
LANDING

[ ] Airspeed -- 80 KIAS on approach
70 KIAS on final
[ ] Trim -- ADJUST
(with NumLock off press NumPad 1 or NumPad 7
as necessary)
[ ] Touchdown -- ALL THREE WHEELS SIMULTANEOUSLY
[ ] Throttle -- IDLE
(press F2 as necessary)
[ ] Braking -- MINIMUM REQUIRED
(press PERIOD key)

____________________________________
SECURING AIRPLANE

[ ] Boost Pump -- OFF
[ ] Engine -- RUN for 1 Minute at 1000 RPM
[ ] Throttle -- IDLE
(press F2 as necessary)
[ ] Avionics Switch , Electrical Equipment -- OFF
[ ] Mixture -- IDLE CUT-OFF (pulled fully out)
(press CTRL+SHIFT+F2 until fully out)
[ ] Ignition Switch -- OFF
(press M+MINUS key until Off)
[ ] Master Switch -- OFF


NOTE: This aircraft's real-world checklists have been modified for use with Flight Simulator 2000. To learn about using, printing, and customizing checklists: in the "Getting From Here to There" section of Simulator Help, click "Using the Kneeboard."