REGISTRATION
------------
The software you've downloaded is complete and fully working, but RealCRT gauges
simulate a failure after 10 min of work.
To suppress this limitation you must register to get a key code.
The cost of registration is US$19
Notice : only 1 registration is necessary per user, to get the right to use
the complete panel and/or gauges on an unlimited number of panels.
*** WARNING !!! ***
Because of the particular display interface of Vectorial Design, the author
cannot guarantee that this software will support all configuration, especially
3D cards. However, thanks to users feedback, most of the common configurations
are now supported.
Before registering, use the trial period to determine if this software
supports your configuration with no problems (try many video modes in 2D and 3D).
After registration, no money will be refunded.
However, in any case, if you encounter problems try to contact the author.
He will do his best to resolve them...
In order to help him, please:
- Indicate your configuration (processor, memory, video cards, Operating System, etc.)
- Mention all message boxes, if any are displayed when the problem occurs
- Look in your Gauges folder for any file with a ".err" extension
- Attach all .err files or contents to your E-mail
Registration on the web
-----------------------
This program can be registered through RegNet - The Registration Network.
RegNet #2524
RegNet can be reached on the World Wide Web at the following URL:
http://www.reg.net
or by calling 1 800 WWW2REG (1 800 999-2734) or (805) 288-1827.
You can go directly to "TOP AVIONICS 747-400 Panel" registration page at :
http://www.reg.net/product.asp?ID=2524
HOW TO GET YOUR SERIAL NUMBER
-----------------------------
First install Navigation Data version 2.0 or higher, and then this panel.
From the Start menu, select Program / Navigation Data 200x / VD Registration.
Your Serial Number is displayed : communicate it when registering.
After registration :
- start again VD Registration
- type your names and key code in the appropriate edit boxes
- then click the Register button.
- you will see a confirmation message
In case of error, check :
- letter cases ("a" or "A")
- "O" (letter) instead of "0" (zero), or the opposite, or other equivalent mistake.
Notice : The key format is "nnnnlll" with nnnn = digits and lll = letters.
In case of a problem, contact the author directly.
If the registration is OK, your Serial Number is displayed - instead of "UNREGISTERED" - on
the initialization screen, when you load a RealCRT gauge.
*** IMPORTANT ***
In order to keep your registration in case of a hard drive problem, please, press the
Backup button after registering.
You will need a formatted diskette.
When the backup is OK, keep the diskette in a safe place.
In case of a new installation, run VDRegister again, then press the Restore button.
You will then need the backup diskette.
When the restore is OK, quit immediately WITHOUT pressing the Register button !!!
The backup diskette is *** STRICTLY PERSONAL ***
This is *** absolutely forbidden *** to distribute its files.
